Stamping parts of hardware automobile are very common now in China

2019-12-09 17:21:47

First of all, we will see whether the data of automobile stamping parts can pass the customs. In some automobile manufacturing enterprises, in order to increase the weight, manufacturers will replace steel with plastic or light data as the original data of automobile parts. This may save fuel, but for those who are concerned about the weight of the vehicle, it does not meet the requirements.

The big feature of metal automobile stamping parts is that they have high dimensional accuracy, uniform size with the module, good interchangeability, and can meet the general assembly and use requirements without further machining. Moreover, the appearance of metal stamping parts is smooth and beautiful, which provides convenient conditions for surface painting, electroplating, phosphating and other surface treatment. Therefore, many manufacturers choose this kind of stamping parts Stamping method.

Metal stamping parts are now very common in China, and there are countless manufacturers, large and small. In the stamping process of hardware stamping parts, if you don't pay attention, the surface is easily damaged, then how to solve this problem?

Install guards. Due to the small production batch, safety protection devices must be installed in the stamping operation which can not realize automation or use safety stamping tools, so as to prevent injury accidents caused by operation errors. All kinds of protective devices have their own characteristics and use range. If they are not used properly, injury accidents will still occur. Therefore, it is necessary to make clear the functions of various protective devices so as to ensure the correct use and safe operation.

However, there is also a problem that has to be considered, that is, when the stamping production is carried out, due to the complexity of the production site, there are likely to be some problems, so for the manufacturer, how to avoid these problems of stamping parts has become the primary problem to improve the processing quality and efficiency.

To solve this problem, we need to proceed from the reality to avoid the problem as much as possible. For example, one part of a car is called the middle cover bracket. The so-called middle cover bracket is mainly a part used to ensure the stability and reliability of various automobile instruments. Therefore, the middle cover bracket must have certain bending resistance and good toughness. Therefore, in the process of stamping parts processing, we should select appropriate materials and process according to the process requirements.